Angular Limits: Difference between revisions
m
Add related articles and link to existing pages
Nikitaivanov (talk | contribs) (Created page with "Changes a constraint's angular limits. Set the lower limit higher than the upper limit for completely unlimited movement. Examples: * Lower 0,0,0 and Upper 180,0,0 allows the part to rotate up to 180 degrees (half of a full rotation) in one direction around the X axis (the right arrow when looking from the top down), similar to a lever * Lower 0,0,-360 and Upper 0,0,360 allows the part to rotate up to a full turn in both directions around the Z axis (the up arrow), simi...") |
-u ndefined- (talk | contribs) m (Add related articles and link to existing pages) |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
Changes a constraint's angular limits. Set the lower limit higher than the upper limit for completely unlimited movement. | {{Block | ||
|image=Angular Limits.png | |||
|type=s | |||
|folder=physics | |||
|input1={{Port|e|Before}} | |||
|input2={{Port|c}} | |||
|input3={{Port|v|Lower}} | |||
|input4={{Port|v|Upper}} | |||
|output1={{Port|e|After}} | |||
}} | |||
Changes a [[constraint]]'s angular limits. | |||
Set the lower limit higher than the upper limit for completely unlimited movement. | |||
== Examples == | |||
* Lower 0,0,0 and Upper 180,0,0 allows the part to rotate up to 180 degrees (half of a full rotation) in one direction around the X axis (the right arrow when looking from the top down), similar to a lever | * Lower 0,0,0 and Upper 180,0,0 allows the part to rotate up to 180 degrees (half of a full rotation) in one direction around the X axis (the right arrow when looking from the top down), similar to a lever | ||
* Lower 0,0,-360 and Upper 0,0,360 allows the part to rotate up to a full turn in both directions around the Z axis (the up arrow), similar to a steering wheel | * Lower 0,0,-360 and Upper 0,0,360 allows the part to rotate up to a full turn in both directions around the Z axis (the up arrow), similar to a steering wheel | ||
* Lower 0,1,0 and Upper 0,0,0 allows the part to rotate freely around the Y axis (height), similar to a fidget spinner | * Lower 0,1,0 and Upper 0,0,0 allows the part to rotate freely around the Y axis (height), similar to a fidget spinner | ||
== Related == | |||
* [[Add Constraint]] | |||
* [[Linear Limits]] | |||
* [[Angular Motor]] | |||
* [[Angular Spring]] | |||
[[Category:Blocks]] | [[Category:Blocks]] | ||