The Loop block is used to run a script multiple times in the same frame. Often used for processing every element in a list.

Inputs

• Start: The Loop blocks starts looping from the Start input.
• Stop: Then it stops looping once it reaches the Stop input.

Outputs

• Do: Plug this to the script that you want to run for every loop.
• Counter: Outputs the current loop number counting from the Start value. If the Start value is greater than the Stop value, it counts down instead of up.

If you were to start the loop at 0 and stop it at 5, you would loop the script 5 times (Count) and the Counter outputs from 0 to 4 (End). Which shows that the Counter won't output the Stop value by the end of the loop, might want to keep that in mind.